AIO ROBOTICS Zeus Quick Start Manual

Z E U S
QUICK-START GUIDE
A

Getting started

4
1
Open door by lifting up and back
4
Insert power cable in back, switch on
Spool feeds clockwise
7
Wind excess back onto spool
Squeeze tabs with
thumb and index
10
Feed filament all the way down
Recommended: start with a Gcode preloaded test
13
Select a file
Printing starts with automated bed leveling
16
Select OK
Remove
test printout
2
Remove interior packaging
5
Press front on button for 1 second
8
Press control button
11
Prep plate with thin layer of glue
Refer to manual for on-board slicing
14
If .STL is selected you'll be asked to slice
Printing starts after extruder hits target temperature
Extruder will first print a stripe at front of plate
17
Print with lid open for best results
3
Place turnable 3 pins facing down
6
Unwrap filament and feed through tube
9
Press park button
12
Press print to access files
14
Select print
NB: "Box" test file print time:
> 8 mins
Lift glass plate and carefully remove object
18
from plate when printing is complete.