Advertisement
INSTALLATION PROCEDURES
Single-Circuit Fixture Polarity Alignment
• Track polarity is indicated by a grooved polarity line that runs the
entire length of the track.
• All fixtures have indicator arrows designed to point to the track
polarity line.
• To install (Figure 4):
A. Insert the fixture contacts into the track channel.
B. Retract the track latch by gently pulling down.
C. Rotate the adapter 90° so that the polarity arrow points to
the polarity line on the track.
• When the fixture is installed, the track latch will lock the fixture
into the track. NOTE: All latches should face the same direction
after installation.
• Once the fixutre is installed into the track, move the ON/OFF
switch to the ON position.
Two-Circuit Fixture Polarity Alignment
All Con-Tech track fixtures have two contacts in the base that
engage conductors within the track; one for neutral and the other
for the positive (live) conductor. Dual circuit tracks contain one
neutral and two positive conductors.
• To engage the second live conductor (Figure 5):
A. Identify the "POSITIVE" connections on the lighting fixture
base, marked "P".
B. To access the second circuit, pull up the connector marked
"P" to the position shown.
C. Slide the plastic shim (shipped with track) beneath the
connector, locking the tabs in place.
• Follow fixture installation instructions for Single-Circuit Fixtures.
IMPORTANT SAFETY INSTRUCTIONS:
• Read all the instructions before installation. Save instructions for
later use.
• Turn off power at fuse or circuit breaker box before installation
or before doing any maintenance work.
• Wear rubber soled shoes should and work on a sturdy wooden
or non-conductive ladder.
• Product must be mounted in locations and at heights in a manner
consistent with its intended use, and in compliance with National
Electrical Code and local building codes. For indoor use only.
• Do not exceed the nominal supply voltage or amperage ratings.
• Do not install any lampholder closer than 6" from any curtain or
similar combustible material.
• Installing contrary to instructions may cause unsafe conditions.
• Warning: Risk of fire. Most dwellings built before 1985 have
supply wire rated at 60°C. Consult a qualified electrician before
installation.
• CAUTION: To reduce the risk of fire and electrical shock, use
only fixtures and fittings intended for use with the Con-Tech
single circuit or 2-circuit, 120v systems.
• The track and all components are rated for 120V, 20A capacity.
(2400W max at 120V)
• Do not exceed the nominal supply voltage or amperage rating.
• To avoid hazards to children, account for all parts and properly
dispose of all packing materials.
• Call the Technical Support department at Con-Tech Lighting with
any installation questions: 847.559.5500.
All specifications subject to change without notice.
1-847-559-5500
www.con-techlighting.com
For Con-Tech Lighting LT Series Single- and Two-Circuit Track
A
Polarity Line
B
Track Latch with
Polarity Arrows
Switch
C
Polarity Line
Track Latch with
Polarity Arrows
A
Polarity Line
B
C
Polarity Line
Track Latch with
Polarity Arrows
This document can be recycled.
LT INST
Advertisement
