Advertisement
4. OPERATING
WARNING! Before use, ensure that you have read, understood and apply Section 1 safety instructions.
DANGER! The press is purpose designed to withstand greater loads than the hydraulic unit can develop. For safety reasons, always
ensure the workpiece is secured on the work table to ensure loads that flex will not suddenly "give" causing danger to operator or
damage to component. Ensure you have read and understood Section 1 safety instructions.
4.1
OPERATING
4.1.1
Place the "V" blocks (item 16) onto the work table, then place workpiece onto the "V" blocks Note: Care must be taken to ensure that
the "V" blocks do not fall from the work table. If necessary hold the configuration in position with clamps.
4.1.2
Turn control valve knob clockwise to close valve.
4.1.3
Pump handle to apply load to the workpiece.
WARNING! DO NOT apply off-centre loads.
4.1.4
When work is done, stop pumping the handle. Slowly and carefully release load from workpiece by turning control valve knob
counter clockwise, in small increments.
Note: Always keep the hydraulic unit fully retracted after use to avoid ram corrosion.
4.1.5
Once the hydraulic unit has been fully retracted, remove the workpiece from the press.
5. MAINTENANCE
Note: Maintenance and repair must only be carried out by a qualified person. Contact your Sealey dealer for details.
5.1
Always keep the press clean, dry and lubricate all moving parts at regular intervals.
5.2
When not in use always store in a dry location with the hydraulic unit fully retracted.
5.3
Should you need to check or replace oil, ensure the hydraulic unit is fully retracted. Remove the oil reservoir filler plug and top
up using Sealey hydraulic jack oil (Sealey Part No's: HJO500MLS/HJO5LS). DO NOT use brake fluid. After filling, purge the system
as described in Section 3.7 to remove any air.
To obtain a parts list and diagram please log on to www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500
IMPORTANT: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THE PRESS.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN PRODUCT TO US. Please telephone us on 01284 757500 to obtain the address and phone number of your local agent.
If product is under guarantee please contact your dealer.
De-commissioning Product
Should the product become completely unserviceable and require disposal, draw off the oil into an approved container and dispose of the
product and the oil according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited 2012
Parts support is available for this product.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
Web
01284 703534
email
YK4B
www.sealey.co.uk
sales@sealey.co.uk
Issue No: 1 - 01/08/12
Advertisement
