Summary of Contents for Tranquil Ease HC-2H
- Page 1 TWO MOTOR MASSAGE & HEAT OPERATING INSTRUCTIONS HC-2H N112 W14600 MEQUON ROAD GERMANTOWN WI 53022 PH 888-987-1011 Raffel Systems copyright 2011 WWW.RAFFEL.COM...
- Page 2 HC 2H IMPORTANT SAFETY INSTRUCTIONS Two Motor Massage WARNING: To reduce risk of injury to persons: READ INSTRUCTIONS BEFORE OPERATING. with Heat INJURY MAY RESULT FROM IMPROPER USE. NEVER REMOVE COVERS. This appliance should never be left unattended when in operation. •...
- Page 3 2 MOTOR MASSAGE WITH HEAT P a g e...
- Page 4 Heat pad will be glued to a small piece of 1.0 fiber and placed into the lumbar area of the inside back. There should be a thin layer of inside back fill between the cover and the heat pad. The remaining inside back fill is helping to hold the heat pad in place. The cord will be positioned to the bottom (as shown above) and run out the back of the back.
- Page 5 wires from the heat pad and motors should be zip-tied together in the back frame, making sure wires are not crimped. The adaptor connection (shown with the red arrow above) should be attached to the bottom rear back frame with a clip. The Power Source/Transformer is plugged into the connection and then into the wall outlet.
Need help?
Do you have a question about the HC-2H and is the answer not in the manual?
Questions and answers