Philips SalonStraight Ceramic HP4642/00 Manual page 10

4222 002 62411
Never leave the appliance unattended when it is plugged in. Never
put the appliance on a surface that is not heat-resistant when it is
heating up and when it is hot.
3 Select the preferred temperature setting by turning the
adjustment knob to the preferred position (1 to 25) (fig. 2).
4 Comb or brush your hair so that it is disentangled and smooth
(fig. 3).
Use a comb to divide the hair into sections. Do not put too much hair
in one section.
Tip: it is better to section off the crown area and to straighten the hair
B
underneath first.Then straighten the top area.
5 Take a section that is approximately 3-4 cm wide. Place it
between the straightening plates and press the handles of the
appliance firmly together.
6 Slide the straightener down the length of the hair in a few
seconds, from root to hair end, without stopping to prevent
overheating (fig. 4).
7 Repeat this process after 20 seconds until you have achieved the
desired look.
8 Allow your hair to cool down. Do not comb or brush it before it
has cooled down, as this would ruin the hairstyle you have just
created.
Cleaning
1 Make sure the appliance is switched off and unplugged.
2 Let the appliance cool down completely on a heat-resistant
surface.
3 Clean the appliance with a damp cloth.
19-10-2005 15:36 Pagina 9 (Zwart/Process Black
ENGLISH 9