Alignment And Adjustment - Samsung CN331EBZX/DIS Service Manual

4. Alignment and Adjustments
4-1 Preadjustment
4-1-1 Factory Mode
1. Do not attempt these adjustments in the Video
Mode.
2. The Factory Mode adjustments are necessary
when either the EEPROM (IC902) or the CRT
is replaced.
3. Do not tamper with the ÒAdjustmentÓ screen
of the Factory Mode menu. This screen is
intended only for factory use.
4-1-2 When EEPROM (IC902) Is Replaced
1. When IC902 is replaced all adjustment data
revert to initial values. It is necessary to
re-program this data.
2. After IC902 is replaced, warm up the TV for
10 seconds.
4-2 Factory/Service Mode
4-2-1 Procedure for the "Adjustment" Mode
1. This mode uses the standard remote control.
The Service Mode is activated by entering the
following remote-control sequence :
(1) DISPLAY®FACTORY.
(2) STAND-BY® MUTE® 1® 8® 2
®POWER ON.
2. The ÒSERVICE (FACTORY)Ó message will be
displayed. The Service Mode has four compo-
nents: Adjustment, Option Bytes and Reset.
3. Access the Adjustment Mode by pressing the
ÒVOLUMEÓ keys ( Up or Down). The adjust-
ment parameters are listed in the accompany-
ing table, and selected by pressing the CHAN-
NEL keys ( , ).
Samsung Electronics
4-1-3 When CRT Is Replaced
1. Make the following adjustments AFTER set-
ting up after setting up purity and conver-
gence :
White Balance
Sub-Brightness
Vertical Center
Vertical Size
Horizontal Center
4. Selection sequences for the PAL N system:
DOWN or UP key:
AGC>VCO>SBT>SCT>RG>GG>BG>SC>
PCR> PSL>PVS>PVA>PHS>
Selection sequences for the NTSC, PAL M
system:
DOWN or UP key:
AGC>VCO>SBT>SCT>RG>GG>BG>SC>STT>
NCR>NSL>NVS>NVA>NHS>CDL
5. The VOLUME keys increase or decrease the
adjustment values (stored in the
non-volatile memory) when Adjustment Mode
is cancelled.
6. Cancel the Adjustment Mode by re-pressing
the ÒFACTORYÓ or ÒPower OFFÓ keys.
Alignment and Adjustments
HS>CDL
4-1