KAEL Muhendislik Elektronik TC - PT100 Manual page 2

Introduction
based on high level electromagnetic interference, also standardized. There are 4 PT100 sensor
inputs. The transformer core temperature or the ambient temperature can also be measured
from the 4th sensor input if the 3-phase transformer requests the winding temperatures
individually as well as it can be measured. There are 4 relay outputs, ALARM, FAULT, TRIP and
FAN.
The design, hardware and software were entirely made by KAEL engineers.
The state-of-the-art technology has been incorporated into this device and features have been
added that make it easier for the user to use both menus and features. The device has a color
LCD display (TFT).As a memory, the device has its own recording area and records error
reports.
All information and warnings that you need to know about the device are described in the user
manual. Please read this booklet carefully before commissioning your system and your own
safety equipment. Please do not make anything about the topics that are not being understood
without making any contact with our company.
Tel: 0.232.877 14 84 (pbx) Fax: 0.232.877 14 49
Factory: Ataturk Mah. 78 Sok. No:10 Ulucak Village, Kemalpaşa - İZMİR.
Warning
1-
The device must be commissioned and programmed by authorized and qualified persons in
accordance with the instructions in the operating instructions. If necessary, they should also be
inspected by these persons.
2-
Do not open the device, do not make it opened. There are no serviceable parts inside the device
that any other user or person will intervene.
3-
Use the device in accordance with installation instructions
4-
Before making electrical connections to the terminals of the device, make sure that there is no
energy in the cables and terminals. There should not be energy in the panel.
5-
The fuses to be used in the device must be 1A FF type.
6-
Secure the appliance firmly so that it does not swing to the panel with the appliances supplied.
7-
Do not interfere of the keys on the front panel of the device with anything other than your fingers.
8-
Once you are sure that you have cut off your device, wipe it with dry cloth only. Chemicals used
in water or cleaning shall damage the device.
9-
Make sure that the terminal connections are made in accordance with the connection diagram
and not in contact (loose connection or interconnection of multiple copper wires, etc.) before the
device is switched on (before energization).
10-
The above precautions and warnings are for your safety. In case of non-compliance, KAEL
Elektronik Ltd. Sti. or vendors are not responsible.
Developed for winding temperature control of resin or dry type MV transformers. It is