Auto Shut Off - Toastmaster 3332S Use And Care Manual

For best results, check garment labels for the temperature and steam setting recommended by the
fabric manufacturer, or consult the enclosed garment care tips pamphlet for additional information.
To prevent damaging garments from too hot of an iron, it is best to first iron garments that require
a low temperature. If you should need to switch from a high setting to a lower temperature, for
example Cotton to
temperature.
Tips: If you are unsure of a garment's fabric content, start on a low setting and test the iron on an
area of the garment that does not show, such as a seam. Gradually increase the heat setting until
wrinkles remove without damaging the fabric.
To freshen up garments made of velvet, felt, suede or velour, hold the steaming iron horizontally
2 inches above the fabric for a gentle steaming. Make sure the iron does not come in contact with
the fabric.
To prevent shine, iron dark garments or those made of silk, acetate or rayon inside out.
DIAGRAM 2
AUTO OFF/ON
When iron is on, the green
light will come on.
When iron is off, the green
light will go off.
PATENTED AUTOMATIC SAFETY SHUT-OFF
This iron has two kinds of safety shut-off mechanisms. One is a patented, touch-sensitive "brain"
in the handle which turns the iron on or off when it is in the horizontal position. The other is a timer
which automatically shuts the iron off if left on its heel in the upright position for more than 15
minutes.
Horizontal Position: When the iron is plugged in and in the horizontal position, it will remain on
as long as your hand is making contact with the handle. Once you take your hand off the handle,
the iron automatically turns itself off. For example, if you are ironing and leave the iron down on the
ironing board to answer the phone, the iron will automatically begin to de-energize. It will turn back
on as soon as you grip the handle and resume ironing. Important: To return the iron to the desired
temperature, allow it to rest in the upright position until the red POWER ON/READY light goes off.
Upright Position: When the iron is plugged in and resting on its heel, it will remain on for 15
minutes, allowing ample time to reposition garments during the ironing process. If the iron is left
resting for more than 15 minutes, it will automatically shut-off. To begin ironing again after the timer
has shut off the iron, pick it up by the handle. The green and red lights will come on. Turn
temperature dial to desired setting and return iron to its upright position. When temperature setting
has been reached, the red POWER ON/READY light will go out — you are ready to iron.
Silk, allow the iron about 5 minutes to reach the lower
HEATING
AUTO
SHUT-OFF
3
POWER ON/READY
When iron is heating
up or temperature
setting has been
adjusted, the red light
will come on.
When temperature
setting has been
reached, red light will
go off.