Advertisement
P
ERFORMANCE
www.pactoolmounts.com
HANDLELOK STRAP PIVOT REPOSITION
For additional assistance call 888-514-0083 between 8AM-5PM EST or email: info@pactoolmounts.com
The elastomer lock strap can be
repositioned to a higher pivot position to
allow the securing of objects which are
oversized.
STEP 1 –
Remove Strap
Remove the pivot pin to free the strap. You may drive it through the bracket by tapping it with a
punch pin or by grasping the exposed end with a pliers and pulling it through. See figures 2A & 2B
STEP 2 –
Replace Strap and Insert Pivot Pin
Place the strap in line with the pivot pin hole and carefully insert the pin through the bracket
and strap. Allow approximately ¼" of pin to extend on each side. The correct orientation of the strap is
where the circular mark is visible on the underside of strap after assembly. See figures 2C& 2D
Verify that the pin is secure after insertion.
A
DVANTAGE
FIGURE 2A
(Punch Through Method)
FIGURE 2C
C
OMPANY
Please read, understand and follow these
instructions. Failure to properly assemble may
result in personal injury and/or property damage.
Contact PAC customer service for product warranty information.
12-2017
INS-1004
INSTRUCTIONS
FIGURE 2B
(Grip Method)
ORIENTATION MARK
FIGURE 2D
Advertisement
