Related Manuals for RetroBelt EURO
Summary of Contents for RetroBelt EURO
- Page 1 EUROPEAN AND JAPANESE LAP AND SHOULDER SEATBELT KIT INSTALLATION GUIDE MOD E RN SAFE TY FOR YOUR CLASSIC retrobelt www. .com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS WELCOME INSTALLATION HARDWARE PRECAUTIONS INSTALLATION GUIDELINES STANDARD INSTALLATION RETROFITTING INSTALLATION USE AND MAINTENANCE LIMITED WARRANTY INSTALLATION NOTES... -
Page 3: Welcome
This guide does not cover every installation possibility, vehicle, or aspect of the installation process. RetroBelt USA, LLC, or its subsidiaries, assume no responsibility for any installation. This manual may be updated from time to time. -
Page 4: Installation Hardware
INSTALLATION HARDWARE The installation hardware below is designed to cover as many Japanese and European vehicles as possible. If your vehicle has existing anchor points installed, you may not need all of this hardware. Feel free to contact us if you have any questions. The retrofitting instructions in this manual are only to be used as a guide for installing anchor points in vehicles that are not already equipped with them. -
Page 5: Precautions
Federal Motor Vehicle Safety Standards (FMVSS) #209, #302. Legal Disclosure RetroBelt USA, LLC, or its subsidiaries assume no responsibility for proper or improper installation. Every attempt has been made to make this user’s manual as informative as possible. This manual may be updated from time to time. The retrofitting steps in this manual should only be performed by a professional installer to ensure that the installation is as safe as possible. -
Page 6: Installation Guidelines
INSTALLATION GUIDELINES Standard Installation Overview This type of installation is for replacing an existing seatbelt kit. If your vehicle is not equipped with a lap and shoulder system but already has a lap-belt system, you can use the existing lap-belt anchor points, but you will have to add the third anchor point. - Page 7 INSTALLATION GUIDELINES Figure 1 B Pillar Existing Factory Shoulder Hex Bolt Anchor Point Female Buckle Receiver Retractor with Cable End Existing Factory Anchor Point Hex Bolt Hex Bolt Copyright 2017 RetroBelt USA, LLC...
-
Page 8: Retrofitting Installation
INSTALLATION GUIDELINES Retrofit Installation Overview If your vehicle originally was not equipped with seatbelts or only came with lap belts, you will need to create anchor points. This information is only to be used as a guide, and retrofitting should only be performed by qualified professionals to ensure a safe installation. - Page 9 Figure 2 Acceptable range 90° 80° Horizontal line Torso line 22.16º Location of anchor point for upper torso restraint PLACEMENT OF ANCHOR POINTS MARK PLACEMENT OF SEATBELT COMPONENTS Figure 2 continued on next page Copyright 2017 RetroBelt USA, LLC...
- Page 10 INSTALLATION GUIDELINES Figure 2 (continued) Example of no With anchor mount anchor mount installed installed, maximum safety! Detail showing anchor plate installed underneath floor/post Detail showing use of round anchor fastener for use behind fenders, floors, etc. Aline and mark the placement of the Align and mark placement of anchor points, Install the retractor, shoulder mount and buckle end to the anchor points.
-
Page 11: Use And Maintenance
If the fixed end of a seatbelt is too long to allow a snug fit on a small occupant, do not use the belt. Children weighing less than 80 lbs should only be secured in an approved child safety or booster seat according to the manufacturer’s recommendations. Copyright 2017 RetroBelt USA, LLC... -
Page 12: Limited Warranty
RetroBelt USA, LLC, or damage that is attributable to acts of God. -
Page 13: Installation Notes
INSTALLATION NOTES Copyright 2017 RetroBelt USA, LLC... - Page 14 MODERN SAFETY FOR YOUR CLASSIC RetroBelt USA, LLC, 7470 Commercial Way, Henderson, NV 89011 p) 702.483.2222 | f) 702.483.2229 | www.retrobelt.com...
Need help?
Do you have a question about the EURO and is the answer not in the manual?
Questions and answers