Page 1
Sound Systems 541-888-3517 fax 541-888-4846 dieter@kksound.com www.kksound.com Installation Instructions Meridian Acoustic Guitar Microphone System Meridian Acoustic Guitar Microphone System Meridian Acoustic Guitar Microphone System Meridian Acoustic Guitar Microphone System First time Installation Separate the 2 clamp parts. They are held together by Velcro.
Page 2
Tightly press the 2 clamp parts towards each other while snapping the Velcro together. If done properly the non-slip-padding will now hold the clamp and mic securely to the instrument. If necessary you can further tighten the clamp by following the instructions below. For a start, position the mic as shown.
Page 3
Connect the Meridian Mic to the Mic In and use an XLR microphone cable to connect the preamp’s OUT to an XLR input of a PA or amp. The preamp works on phantom power via the XLR output, or...
Page 4
Frequency response curve - Microphone Special note regarding phantom power: The Meridian preamp works on 12-48 volt phantom power or on 12VDC power via a suitable power supply like the one we sell for this microphone system. Phantom power is unfortunately not 100% standardized and differs in respect to how clean and hum-free it is.