Getting Started; Accessories List; Installing The Stand Or Wall Mount Bracket; Tv Front - Toshiba 43U5865 Series Owner's Manual

Accessories List

The following accessories are included with TV:
OWNER'S MANUAL× 1 Base Stand × 2
AAA Battery × 2 Screw × 4
Power Cord × 1

Installing the Stand or Wall Mount Bracket

Installing the Stand
CAUTION
• Be sure to disconnect the A/C power cord before installing a stand
or Wall-Mount brackets.
• The LED display is very fragile, and must be protected at all times
when installing the base stand. Be sure that no hard or sharp
object, or anything that could scratch or damage the LED display,
comes into contact with it. DO NOT exert pressure on the front of
the TV at any time because the screen could crack.
1. Carefully place your TV face-down on a soft, flat surface to
prevent damage to the TV or scratching to the screen.
2. Remove the 2 stands from the accessory bag and then insert the
stands into the bottom slots of the TV.
3. Secure the Base Stand to the TV with the 4 screws in accessory
tightly.
leg
Installing the Wall Mount Bracket (not included)
Wall mount hole pattern VESA (mm)
Wall mount screw size (mm)
9.5 -11.5 mm
Rear cover of the TV
Follow instructions provided with the Wall mount bracket.
NOTE
The diameter and length of the screws differ depending on the wall
mount bracket model.

Getting started

Remote Control × 1
leg
Screws:
M4×40(43")
M4×12(50"/55")
M5×12(65")
200 × 200 (43"/50")
300 × 200 (55")
400 × 200 (65")
M6
Wall mount bracket
(not included)
Screw (not included)
Spacer (not included)

TV Front

50" / 55" Joystick button
(Remote sensor / Power indicator / Standby)
43" / 65" Joystick button
(Remote sensor / Power indicator / Standby)
Item Description
Receive remote signals from the remote control.
Remote
Do not put anything near the sensor, as its function
sensor
may be affected.
Power The light is red in standby mode, the light is green
indicator when TV is on.
Press the joystick button when in standby mode, TV
will be turned on. Press the joystick button to call up
the menu, when the focus is on "Power Off", press the
Standby /
joystick button to turn the TV into standby mode.
Source
/ Press the joystick button to call up the menu and
then select among the different input signal sources.
Toggle the joystick button left and right to adjust the
volume.
VOL + / -
Toggle the joystick button forward and backward to
control the channel.
CH + / -
NOTES
Powering on the TV requires several seconds to load
programmes. Do not rapidly turn the TV off as it may cause the
TV work abnormally.
5