CREE LIGHTING SmartCast CSC-GW-CWC-W Manual page 3

TROUBLESHOOTING:
If LEDs do not illuminate:
1. Check that the ethernet cable is connected to a the power
supply and the power is turned on.
2. Check that the network cable is fully seated in the connector on
the back side of the SmartCast Wireless Gateway such that the
locking feature is fully engaged.
STATUS LED INDICATOR TABLE
STATUS CODE
LED COLOR PATTERN
Red Any
Purple 10 Blinks
2 Blink
Blue
4 Blinks
Green Solid
© 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree
registered trademarks and the Cree SmartCast Technology logo is a trademark of Cree, Inc. SmartCast
trademark and OneButton is a trademark of Cree Lighting, A company of IDEAL INDUSTRIES.
TM
3 of 3
Issue
DESCRIPTION
Hardware error. Contact Cree
Lighting Support.
User initiated Factory Reset.
SWG is in DISCOVERY mode.
SWG is in CONFIG mode
System operational. No issues
detected.
®
FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the device.
This device has been tested and found to comply with the limits for
a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the device is operated in a commercial environment.
This device generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of
this device in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his
own expense.
In addition, this device complies with ICES-005 of the Industry Canada
(IC) Regulations.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device. In addition, this device complies with ICES-005 of the
Industry Canada (IC) Regulations.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
and the Cree logo are
, is a registered
®
www.creelighting.com
LPN00655X0001A0_C