Advertisement
Buttons
How to set the temperature
Set the desired cooling temperature by pressing the corresponding button
of the buttons will raise or lower the temperature setting. The temperature selected will flash in the
LED display for approximately 10 seconds, then revert back to displaying the temperature of the
cabinet interior.
CARE AND MAINTENANCE
CLEANING THE DRINKS FRIDGE
Turn off the power, unplug the appliance, and remove all items including shelves.
•
Wipe the inside surfaces with a sponge and baking soda solution. The solution should be about 2
•
tablespoons of baking soda to 1 litre of warm water.
Wash the shelves with a mild detergent solution. Allow wooden shelves to dry before placing back
•
into the wine cooler.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical
parts.
•
Wipe the outside cabinet with warm water and mild liquid detergent. Dry with a clean soft cloth.
Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless
steel with steel particles and rusting may occur. Olive Oil is great to run on stainless for protection
against rust.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your
appliance too much that it spoils drinks. If the power is going to be off for a longer period of time, you
need to take the proper steps to protect your contents.
Keypad introduction
Explanation of the buttons
Press for short press
Toggle ECO mode
Light ON/OFF
Increase set point
Decrease set point
6
Normal operation
Press for long press
Toggle defrost
Power ON/OFF
Toggle
or
/
°
C and
°
F
. Each depression
Hide quick links:
Advertisement
