KingShield AC3000 Installation Instructions

Installation Instructions
For the KingShield Air Curtain

IMPORTANT

This product should be installed by a competent
person and in accordance with the current IEE
Wiring Regulations. If in doubt, consult a qualified
electrician.
• This product is not intended to be used by
children and persons with sensory, physical
and/or mental impairments that would prevent
them from using it safely.
• Extreme caution is necessary where children or
persons with reduced physical, sensory or mental
capabilities may come into contact with the
heater when in use.
• In order to avoid overheating do not cover or
obstruct grilles or air intake openings when
in use.
• The heater must not be located immediately
adjacent to or under/against an electrical
socket outlet.
• Do not operate the heater with a damaged
cord/plug or if heater malfunctions. If the
supply cord is damaged it must be replaced
by a qualified electrician
• Before making any fixing holes make sure
there are no pipes or cables below the
surface.
• Make sure the heater is anchored to a solid
surface which can take the weight of the
heater.
• This heater is for indoor use only.
• This heater must be connected to earth.
• Position the heater ensuring that hot air
cannot blow directly onto flammable surfaces.
• This heater is not equipped with a device to
control the room temperature. Do not use
this heater in small rooms when they are
occupied by persons not capable of leaving
the room on their own, unless constant
supervision is provided.
The Air Curtain unit is designed for easy
installation and can be wall or ceiling mounted.
The unit has a fan and two heat settings and its
angle can be adjusted. This unit is ideal for
providing a heated air curtain if mounted over
doorways and reduces draughts and the
discomfort of cold air when doors are opened.
It is also an ideal choice for heating general
areas.
Switch off mains supply and remove the
appropriate circuit fuse or MCB before
commencing installation or maintenance.
1. Remove the four screws securing the back
mounting bracket.
2. Using the bracket as a template, mark the
fixing holes position.
3. Drill and secure the bracket with suitable
fixings.
4. Re-position the heater back on the bracket
with the four screws, ensuring the serrated
lock washer is in the correct place. Position
the angle of heater as required.
Model No: AC3000
WARNING

INTRODUCTION

INSTALLATION