Advertisement
Black Box and the Double Diamond logo are registered trademarks of BB Technologies, Inc.
Bluetooth is a registered trademark of The Bluetooth SIG, Inc.
Any other trademarks mentioned in this manual are acknowleged to be the property of the trademark owners.
secure the unit to
2. Connect the 3-pin IEC320 AC input connector to a power source. Power on the injector.
3. Using CAT5e or higher cable, connect the RJ-45 port on the injector labeled "IN" to your network switch. See Figures 2 and 3.
4. Connect the RJ-45 port labeled "OUT" on the injector over Ethernet cable to the powered device. See Figures 2 and 3.
Power and data
to powered
device
Data input from
network switch
Figure 3. Cable connections to the power injector.
5. The LEDs will light to diagnose the connection. See Table 1.
LPJ000A-F, version 2
Insert a screw to
a surface
Figure 1. Location of metal feet on the power injector.
Power and
Data in
data out
Front panel.
Figure 2. Ports on the power injector.
Copyright 2011. All rights reserved.
©
FREE, live, 24/7 Tech Support is just 20 seconds away.
724-746-5500 | blackbox.com
IEC-320 power connector.
AC input
LED Name
ON
Fault
Connect
Insert a screw to
secure the unit to
a surface
Back panel.
Table 1. LEDs.
LED Color
Function
Green
Power ON detected
Red
Fault detected
Green
Valid IEEE 802.3af load detected and connected
Advertisement
