Advertisement
1. DISCONNECT ALL POWER BEFORE BEGINNING INSTALLATION
TO PREVENT ELECTRICAL SHOCK AND EQUIPMENT DAMAGE
2. INSTALLER MUST BE A TRAINED, EXPERIENCED SERVICE
PERSON
Stand-Alone Units 2960
• Wire stand-alone unit to appropriate
power supply and fire alarm
• Refer to data sticker for proper
input voltage and current specifications
• Energize power supply
• Open door to hold-open point
Door should hold open
• Depress On/Off Switch. Door should
close and latch
• Adjustment of spring power may be
necessary to ensure proper latching
• Depress on/off switch again. Open door to
hold open position; door will hold open.
A7395C.indd 3
Typical Wiring
Optional remote
release connection
CAUTION: Input power supply must match circuit
board voltage rating, either 24VAC/DC or 120VAC.
CAUTION
3. ALL WIRING MUST COMPLY WITH APPLICABLE LOCAL
ELECTRICAL CODES, ORDINANCES AND REGULATIONS
4. MAXIMUM WIRE SIZE IS 18AWG
On/Off
Switch
Data
Sticker
Earth Ground
3
Negative (-)
2
Positive (+)
1
Opening for
Concealed Wiring
Terminal Strip
for Power Input Connections
Appropriate
Power Supply
A7395C
10/29/18 12:44 PM
3
Advertisement
