Download Print this page

Panduit SDLOCK Series Installation Instructions

Swing handle lock for n-type and s-type cabinets

Download this manual

Swing Handle Lock

Qty: 1

S-Type Single Hinge Door

Lock Swing Handle Replacement

•

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

Swing Handle Lock Key

Qty: 2

Swing

Handle

Remove Cam Screw (use 10mm socket wrench), Cam Stop (note orientation of Cam Stop), and Cam from existing handle

Remove Door Handle Backing Plate and remove existing door handle (use 10mm socket wrench)

Install Swing Handle by securing Door Handle Backing Plate to Swing Handle (use 10mm socket wrench)

Install Cam, Cam Stop, and Cam Screw (use 10mm socket wrench)

When replacing Cam Stop, ensure that the orientation is the same as when it was removed.

for N-Type and S-Type cabinets

Tool List:

• 10mm Hex Driver

Cam

Stop

Page 1 of 2

Swing Handle Lock

Part Number(s) : SDLOCK-XXX

Cam

Door Handle

Backing Plate

V00029PV

Cam Screw

Page 1 Swing Handle Lock for N-Type and S-Type cabinets Part Number(s) : SDLOCK-XXX INSTALLATION INSTRUCTIONS V00029PV © Panduit Corp. 2018 Tool List: • 10mm Hex Driver Swing Handle Lock Swing Handle Lock Key Qty: 1 Qty: 2 Stop Cam Screw Swing...
Page 2 INSTALLATION INSTRUCTIONS V00029PV © Panduit Corp. 2018 Door Rods must fit behind Door Rod Guides Door Rod Stop Assembly (see note) Cam Screw Swing Handle Door Handle Backing Plate N-Type Single Hinge Door; N-Type & S-Type Solid Rear Door Lock Swing Handle Replacement •...