Landport Deluxe Manual page 7

INSTALLING THE WEDGE ANCHORS
Step 1
1. Position your Landport where
you want it.
2. Mark the holes with chalk or
other marker.
3. Move Landport out of the way.
Step 2
1. Wrap a bit of visible tape around
the drill bit at 3 ¼"– then you'll know
when to stop drilling.
2. Drill a 3 ¼" deep hole into the
concrete using a 3/8" bit, drilling ¼"
more than the length of the anchor.
3. Clean the concrete dust out of the
hole with a vacuum.
7
Step 3
1. Remove the nut and the washer
from the wedge anchor.
2. Hammer the wedge anchor bolt
into the hole. The threaded part of
the bolt should be up, such that the
wedge is in the bottom of the hole.
Step 4
1. Place the shoe over the wedge
anchor bolt and position the Landport
over the shoe and the bolt.
2. Attach the washer and the nut to the
anchor bolt from inside the Landport.
3. Tighten the nut 2 - 3 complete
turns. This will cause the wedge to
expand and anchor into the concrete.
8