Page 1
Release Date:18.8.2005 Page: 1 / 6 Document number: 0523001 Document type: Technical Document Product name and version: SANAKO Lab 100, MSU322/642 MSU322/MSU642 SOFTWARE INSTALLATION NOTE: THE MSU HARD DISKS WILL BE INITIALIZED IN THIS PROCEDURE. ALL EXISTING DATA WILL BE REMOVED FROM THEM.
Page 2
Release Date:18.8.2005 Page: 2 / 6 Document number: 0523001 Document type: Technical Document Product name and version: SANAKO Lab 100, MSU322/642 INITIALIZING THE MSU SOFTWARE 1. In the MSU, switch on the mains power (5.). Do not start the MSU yet.
Page 3
Page: 3 / 6 Document number: 0523001 Document type: Technical Document Product name and version: SANAKO Lab 100, MSU322/642 5. In BIOS select the Boot tab and then Removable Drives by pressing the Enter key. 6. Select the USB memory stick as the boot device by pressing the “–“...
Page 4
Page: 4 / 6 Document number: 0523001 Document type: Technical Document Product name and version: SANAKO Lab 100, MSU322/642 8. Make sure that the MSU is booted from the USB memory stick and that the following screen appears after startup.
Page 5
Page: 5 / 6 Document number: 0523001 Document type: Technical Document Product name and version: SANAKO Lab 100, MSU322/642 10. Existing installation detected. To preserve the existing media files on your hard drive, select Yes. 11. Preparing system for installation.
Page 6
Release Date:18.8.2005 Page: 6 / 6 Document number: 0523001 Document type: Technical Document Product name and version: SANAKO Lab 100, MSU322/642 12. Restoring partition from image file 13. Software restore is complete. Lab100 software is now installed onto the MSU.