PRYME Radio Products PRYMEBLU BT-PTT-ZA User Manual

PRYMEBLU® BT-PTT-ZA
Push-to-Talk User's Guide
For use with Zello and other push-to-talk apps on Apple iOS smart phones.
Model No.: BT-PTT-ZA
Made in Taiwan
PRYME® and PRYME BLU® are trademarks owned by PRYME Radio Products,
Brea CA. All other product or service names are the property of their respective owners.
© 2014 PRYME Radio Products, Brea CA. All Rights Reserved
Controls and Connection
Battery Holder
Located inside the housing of the
Push-to-Talk, the battery slot holds one
coin cell battery which power the device.
PTT Button
Press this button to activate
the Push-to-Talk function of
the Zello app
Velcro Fastener
The Velcro fastener is used
to secure the BT-PTT-ZA to your
person or any other convenient
location during use.
2
Installing or Replacing the Battery
The BT-PTT-ZA uses one replaceable CR2032 coin cell type battery. The rst time you use
your BT-PTT-ZA you will need to install a new battery. You will also need to replace the
battery at the end of its lifetime. A single battery can provide up to one full year of
operating time. However, operating time can vary depending on usage cycle and the
age and condition of the battery.
Rotate Housing
to Access Battery
To change the battery:
1. Separate the two halves of the BT-PTT-ZA housing by securely holding the back cover and
rotating the front cover in a counter-clockwise direction until the two halves come apart.
2. Locate the battery holder inside of the device. Remove the old battery from the
battery holder if one is installed. A ball point pen can be used to push the battery out of
the holder if needed.
3. Insert a new CR2032 3-volt coin cell battery into the battery holder, observing proper
polarity. The positive side of the battery (marked with a "+" sign) should face away from
the circuit board.
3. Reinsert the two halves of the transmitter housing and rotate the top cover clockwise
to tighten.
3