Summary of Contents for OneRemote 30012601
- Page 1 BeoLink Compatible OneRemote iPod Dock Type 30012601 (for most iPods, including Touch and iPhone) Made in Denmark by www.oneremote.dk...
- Page 2 (Press for 2 secs)*3 Volume down Volume up By selecting the correct source on the Bang & Olufsen remotecontrol terminal, the OneRemote iPod Dock is automatically turned on. Note ! When your iPod is inserted into the dock, it is operable after exchanging data with the dock within 10-15 secs.
-
Page 3: Table Of Contents
List of Contents Getting Started ................page Direct Mode or CableLink Mode ..........page Factory Settings ................ page Installation ................page Examples of Bang & Olufsen Set Ups ........page Setting Up the iPod Dock ............page Option Programming ..............page Source and Option Selection ............ -
Page 4: Getting Started
– see below – the docked device might even be controlled from there. Connect the OneRemote iPod Dock to a Bang & Olufsen audio- or videosystem as any vacant audio- or AV input source. Setting up Bang & Olufsen systems may vary, and this user guide describes how. -
Page 5: Installation
Set Up for Direct Control The OneRemote iPod Dock is connected as an AV source A OneRemote iPod Dock may be connected to any TV, and to an AV input in a Bang & Olufsen TV. with a dock in each room individual program selection is When selecting the dock connected source with the Bang possible- and every docked iPod is always fully charged. -
Page 6: Setting Up The Ipod Dock
Setting up the OneRemote iPod Dock for the Direct Mode - using a Bang & Olufsen Remote Control In the Direct Mode the Bang & Olufsen remote control signal controls both the OneRemote iPod Dock and the Bang & Olufsen equipment at the same time. -
Page 7: Source And Option Selection
One Remote iPod Dock should be. The OneRemote iPod Dock has to be programmed with the right option to operate correctly. See page 5 and 6. - Page 8 Input Socket Selected Source Direct CableLink Remarks Option Option A.AUX BeoSound 9000 SHIFT RADIO A.MEM ATAPE Input Socket Selected Source Direct CableLink Remarks Option Option A.AUX BeoSound 3000 SHIFT RADIO BeoSound 3200 A.MEM ATAPE N.MUSIC A.MEM2 SHIFT ATAPE N.RADIO PHONO Input Socket Selected Source Direct...
- Page 9 Input Socket Selected Source Direct CableLink Remarks Option Option A.AUX *1 *4 BeoCenter 2300 SHIFT RADIO A.MEM *1 *4 ATAPE N.MUSIC *1 *4 A.MEM2 SHIFT ATAPE N.RADIO *1 *4 PHONO V.TAPE V.MEM DTV – SAT Input Socket Selected Source Direct CableLink Remarks Option...
- Page 10 Input Socket Selected Source Direct CableLink Remarks Option Option TAPE2 N.MUSIC *1 *4 BeoCenter 8000 A.MEM2 SHIFT A.TAPE Input Socket Selected Source Direct CableLink Remarks Option Option TAPE2 N.MUSIC *1 *4 BeoCenter 8500 A.MEM2 BeoCenter 9000 SHIFT A.TAPE BeoCenter 9500 A.AUX Input Socket Selected Source...
- Page 11 AVANT all models All newer TV-models may be connected via the AV input sockets too…………… *9 connection to an AV input on the TV using the OneRemote Adaptor, type 39207496. Check the TV user guide for setting up the AV inputs.
-
Page 12: Setting Up The Ipod Dock
Appropriate but not included cables have to be used to show video signals. This OneRemote iPod Dock has both RGB and Composite Video outputs. OneRemote Adaptor, type 39207495... -
Page 13: Connecting As An Av Source
Connecting as an AV (scart) Source Connect the dock as an AV source to any Bang & Olufsen TV, using a OneRemote Adaptor, type 39207495. The dock must be option programmed to the CableLink mode (page 6) and the source must be programmed, i.e. - Page 16 2601u10uk...