TPS Manual Table of Contents Table of Contents 1 Compliance 2 Overview 3 Common Features 4 TPS80W Triple Power Supply 4 TPS30 MAX Triple Power Supply 5 TPS30 Mini Triple Power Supply 5 ...
(2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Intellijel Designs, Inc. could void the user’s authority to operate the equipment. Any digital equipment has been tested and found to comply with the limits for a ...
Overview The TPS series of busboards and power supplies provides high power, efficient and low noise studio-grade power to your Eurorack Modular case. It was designed to perform optimally with even the most demanding, noisy and power hungry modules available today. ...
TPS Manual Common Features All TPS models share the following features: ● Low impedance star distribution due to 4 layer PCB ● Triple 120° phased controller for low induced noise ● Output short circuit protection and foldback current limiting ●...
TPS Manual TPS30 MAX Triple Power Supply In addition to the common features mentioned earlier, each TPW30 MAX has the following additional attributes: ● 30 Watt integrated switching power supply ● +12V output at 1500 mA, -12V output at 1500 mA, +5V output at 1000 mA ●...
This can mean: 1) using an Intellijel Power Entry module (3U or 1U), or 2) using an Intellijel case with a built-in Power Entry, or 3) building your own DIY solution. The illustration to the right shows ...
TPS Manual Connecting Eurorack Modules Running around the circumference of the three TPS busboards are the power headers. These headers power your eurorack modules using the ribbon cables included with each of your modules. ...
Connecting 5V Devices Connect these 5V connectors to any modules that require a 5V power source. You can also use this to power an Intellijel USB Power 1U module, which (for example) is useful for connecting a small USB gooseneck LED light. ...
Page 10
TPS Manual 2. As described previously, connect the RED wire from the Power Entry point to the first busboard’s POSITIVE terminal, and connect the BLACK wire from the Power Entry point to the first busboard’s NEGATIVE terminal. Some boards have two pairs of DC connectors, so simply connect the RED wire to one ...