FIC AquaPAD User Manual

Copyright
Copyright © FIC (First International Computer). Corporation 2001. All right reserved.
Disclaimer: FIC Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for
incidental or consequential damages resulting from furnishing this material, or the performance or use this product.
FIC Corporation reserves the right to change product specification without notice. Information in this document
may change without notice.
No part of this document may be copied, reproduced, or transmitted by any means, for any purpose without prior
written permission from FIC Corporation.
Safety Instructions
The AquaPAD has been tested for conformance to international safety regulations. Like any electronic device,
however, the AquaPAD should be used with care. To protect yourself from possible injury and to minimize the risk
of damage to the AquaPAD, read and follow these safety instructions:
General Guidelines
♦
Read all of these instructions.
♦
Save these instructions for future use.
♦
Follow all warnings and instructions marked in the AquaPAD.
♦
Except as explained elsewhere in this manual, do not attempt to service the AquaPAD yourself. Opening or
removing covers that are marked "Do Not Remove" might expose you to dangerous voltage points or other risks.
Refer all servicing of marked components to qualified personnel.
Installation Restrictions
1. Follow all warnings and instructions marked on the product.
2. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a
damp cloth for cleaning.
3. Do not use this product near water. For example, near a bathtub, washbowl, kitchen sink or laundry tub, in a
wet basement or near a swimming pool.
4. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to
it.
5. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be remote risk of
electric shock from lightning.
6. Do not use the telephone to report a gas leak in the vicinity of the leak.
7. Slots and openings in the cabinet and the back or bottom are provided for ventilation; to ensure reliable
operation of the product and to protect it from overheating, these openings must not be blocked or covered. The
product should never be placed near or over a radiator or heat register, or in a built-in installation unless proper
ventilation is provided.
8. This product should be operated from the type of power indicated on the marking label. If you are not sure of
the type of power available, consult your dealer or local power company.
9. Do not allow anything to rest on the power cord. Do not locate this product where persons will tread on the cord.
10. If an extension cord is used with this product, make sure that the total ampere rating of the equipment plugged
into the extension cord does not exceed the extension cord ampere rating. Also, make sure that the total rating
of all products plugged into the wall outlet does not exceed the fuse rating.
11. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage
points or short out parts that could resulting a fire or electronic shocks. Never spill liquid of any kind on the
product.
12. To reduce the risk of fire, use at least No. 26 AWG wire for the telecommunication line cord.
13. Always disconnect all telephone lines & all power cords from the wall outlet before servicing or disassembling
this product. And, refer it for servicing to qualified service personal under the following conditions:
a. When the power cord or plug is damaged or frayed.
b. If liquid has been spilled into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally when the operating instructions are followed. Adjust only those
controls that are covered by the operating instructions, since improper adjustment of other controls may
result in damage and will often require extensive work by a qualified technician to restore the product to
normal condition.
e. If the product has been dropped or cabinet has been damaged.
f. If the product exhibits a distinct change in performance, indicating a need for service.
1