Advertisement
Quick Links
Safety Information
WARNING: Improper use of this product or failure to follow these
instructions may result in equipment damage, personal injury, or
death. Read and understand all instructions for proper installation
and use of this product.
WARNING: Before loading equipment in the cabinet, be sure all
parts and hardware are properly installed and tightened.
Intended Use
Install Floor Supported Cube-IT only in indoor, environmentally controlled areas;
do not use outdoors, in harsh environments or in air-handling spaces. Use this
rack for computer equipment, including servers and peripherals. Allow only
qualified service personnel to use this enclosure.
Tools Required
13mm Socket
10mm Socket
T25 TORX Driver
T30 TORX Driver
#2 Phillips Screw Driver
#1 Flat Screw Driver
3/8" Socket Extension
5/32 Drill Bit
Installation Instructions
FLOOR SUPPORTED CUBE-IT
Included Hardware
M8X40 LAG Screws
M5.5X9 TAPTITE Screws
M6X10 Black TAPTITE Screws
M6 Star Washers
Grounding Wire
Cable Grommets
Door Keys
3mm Hex Key
IIS-739928, 11/7/18, Rev. 1, CPI/JAG
800-834-4969 (USA & Canada) • www.chatsworth.com • techsupport@chatsworth.com
For international phone numbers, see our website or contact CPI Tech Support.
This drawing contains proprietary and confidential information and is protected by U.S. and international law. Unauthorized reproduction, disclosure or use of the drawing or
the information therein is expressly forbidden except as agreed to in writing by Chatsworth Products, Inc.
Rear Panel
Center Chassis
Door
Qty 9
Qty 2
Qty 2
Qty 2
Qty 1
Qty 5
Qty 2
Qty 1
LOAD CAPACITY: 1000lb (454kg)
Page 1 of 5
Plinth
Caster Kit
Advertisement
Summary of Contents for Chatsworth Products Floor Supported Cube-It
- Page 1 This drawing contains proprietary and confidential information and is protected by U.S. and international law. Unauthorized reproduction, disclosure or use of the drawing or the information therein is expressly forbidden except as agreed to in writing by Chatsworth Products, Inc.
- Page 2 Installation Instructions FLOOR SUPPORTED CUBE-IT Removing from Pallet Reverse Door Swing (OPTIONAL) 1. Remove carton top and four corner protectors from cabinet. 1. Remove top access panel on rear panel by removing four hex nuts. 2. The wheel kit and plinth ship packaged inside the cabinet. Remove both 2.
- Page 3 Installation Instructions FLOOR SUPPORTED CUBE-IT Caster Kit Installation Plinth Installation 1. Install caster assembly to center chassis bottom using four M8 carriage 1. Lay cabinet on its side and open door to access inside. Place cardboard bolts and serrated flange hex nuts.
- Page 4 Installation Instructions FLOOR SUPPORTED CUBE-IT Mounting Cabinet to Wall NOTE: These instructions are for mounting the cabinet to a wood studded wall covered with 3/4" plywood. For masonry surface, the installer must provide appropriate hardware. 1. Ensure the wall or mounting surface is structurally sound and able to support the cabinet and expected payload.
- Page 5 Installation Instructions FLOOR SUPPORTED CUBE-IT Equipment Rail Adjustment Grounding Wire 1. Loosen M8 bolts, star washers, and hex nuts to move equipment rails to Use M5.5 self-tapping Torx screws, star washers, and grounding wire to desired depth spacing. electrically bond center chassis to rear panel using any accessory holes.