Lumax LX-1310 Instructions

Caution : Recommended for using with Heavy Duty
Wheel Bearing Grease only
Always Wear Appropriate Protective Clothing. Protective Gloves and Non-skid
Footwear are strongly recommended when working with Bearing Packer. Approved
Protective Equipment, such as, Impact Resistant Safety Glasses and/or Safety Goggles
Must be used for Operator Protection.
Instructions :
1. Clean and Inspect Wheel Bearing, checking it for Pitting or Flaking of Rollers or Race.
Race should be clean and shiny.
Note : Use a Petroleum based Cleaner. DO NOT attempt to clean or dry with
compressed air, as this is unsafe and could damage race.
2 . Insert Bearing in the Bearing Packer as shown in the diagram, with narrow end up.
3 . Manually tighten top plate of the Bearing Packer on centered Bearing.
Note : Narrow end up and do not over tighten.
4. Couple Grease Gun to Hydraulic Fitting on the Bearing Packer. Use only Heavy-duty
Wheel Bearing Grease. Do not use Multi-purpose Grease for packing Wheel
Bearings, as it cannot handle the high temperatures of Wheel Bearing applications.
5 . Pump Grease until Bearing is filled and Grease is flowing out the Bearing evenly.
6 . When filled, reverse steps 4, 3, and 2 to remove Bearing from tool.
Note : Excess Grease can be used to pack Bearing Hub
Lumax ® 3705 Centre Circle, Fort Mill, SC 29715, USA
Fax : 803-547-0800
© 2003 Lumax
®
Lumax and the Products described in it are Copyrighted by Lumax
Reserved. This Form may not be Copied in Whole or Part, without the Express Written
Consent of Lumax

Bearing Packer Instructions

www.LumaxLubrication.com
® . All Rights Reserved.
® .
®
, with All Rights
Form : LX-1310-12-IS