Operation; Battery Charging And Monitoring - ION G2 Operator's Manual

OPERATION

1. Make sure your footing is secure and that you have the
unit in the vertical position firmly in your hands.
2. Depress the operating lock lever, then squeeze the
operating trigger. Following a 1/2 second safety delay,
the auger will then start drilling. SEE FIGURE 4
3. To stop the auger, release the operating trigger.
4. When the auger is not in use, remove the battery.
NOTE: For best results on the ice, remove the
battery and put it in a warm place while you're
fishing.
FIGURE 4
Reverse Switch Operation
To use reverse operation function to flush hole of unwanted
debris do as follows: SEE FIGURE 5
1. To activate reverse function, depress the reverse switch
and then depress the operating lock and operating
trigger at the same time.
2. To stop auger release the operating trigger.
To Flush a hole, do as follows:
1. Place the auger half way down the hole with the auger
starting in the hole. The top of the auger flight must be
above the water and slush.
2. Activate reverse function and continue to lower the
auger into the hole. The lower ring of the auger must exit
the bottom of the hole.
3. After a few seconds of reverse operation, release the
operating trigger.
NOTE: KEEP POWERHEAD CLEAR OF WATER.
Water will come back up the hole and overflow.
4. Repeat the above steps three times to clear the hole.
6

BATTERY CHARGING AND MONITORING

OPERATING
LOCK
LEVER
OPERATING
TRIGGER
Charger Indicator Lights and Meaning
Check for parts online at www.ioniceaugers.com or call 800-345-6007 M-F 8-5 CT
REVERSE
SWITCH
FIGURE 5
1. Connect the included power cord into the charger.
Plug the other end into a 120V outlet.
2. Slide the battery into the charger, making sure
the battery pack is fully seated in the charger.
3. The charge indicator light should blink green.
SEE FIGURE 6.
4. When indicator light is lit solid green, the battery
is fully charged.
5. Once the battery has been fully charged, unplug
the charger from the wall.
6. Remove the battery from the charger.
NOTE: Recharging the battery after each use
is best for the life of the battery.
INDICATOR
LIGHT
FIGURE 6
ACTION/COLOR
Flashing green
Solid green
Flashing red
Solid red
Operator's Manual
ION G2 Electric Ice Auger
MEANING
Battery charging
Battery fully-charged
Battery too hot / too cold
Power on