Advertisement
4.
prepariNg the battery
4.1.
Be sure the area around the battery is well ventilated while the battery is being tested.
4.2.
clean the battery terminals. Be careful to keep corrosion from coming in contact with your eyes, nose and mouth.
4.3.
inspect the battery for a cracked or broken case or cover. if the battery is damaged, do not use the tester.
4.4.
if the battery is not a sealed maintenance-free battery, check the level of each cell and if necessary, add distilled
water until the battery acid reaches the level specified by the manufacturer. This helps purge excessive gas from
the cells. Do Not overfill.
4.5.
if necessary to remove the battery from vehicle to test it, always remove the ground terminal from the battery first.
make sure all accessories in the vehicle are off to ensure you Do Not cause any arcing.
4.6.
modern vehicles contain extensive electronic systems. You are required to check with the vehicle manufacturer, for
any specific instructions regarding the use of this type of equipment on each vehicle. No liability will be accepted for
damage / injury, where this product is not used in accordance with all instructions.
4.7.
note: the internal battery is charged during the connection to the battery being tested.
1. Battery clamps (not shown)
2.
Bluetooth status (blue) led
3.
Battery status (green) led
4.
check (red) led.
5. reset power button.
5.
iNstalliNg the app
5.1.
download and install the App "seAleY Bt3000". (App store or Google Pay). look for the
Apple devices it requires ios 8.0 or latter, Android devices, os 4.3 or later.
5.2.
new use setup
When using the App for the first time, you must complete Registration.
1. run the App on your mobile device.
2. Select "NEW USER" (fig.2)
3. Fill in all of the required fields, and then check the box for "AGREE TO TERMS AND CONDITIONS". Press
"CONTINUE" (fig.3)
4. log in: enter the email address provided during registration. check the box for" rememBer Account".
Press "LOG IN". (fig.4)
© Jack sealey limited
Original Language Version
fig.1
icon. note: for
Bt3000 | issue 1 12/04/17
Advertisement
