Advertisement
Place these instructions in the vehicle's glove box after installation is complete.
Important:
Please read these instructions carefully prior to installation.
Please refer to your fitting instruction to ensure that the alloy tray is installed correctly.
Check the contents of this kit before commencing fitment and report any discrepancies.
Item
Component Name
1
Holder Bracket - Bolt Type
2
Holder Bracket - Clamp Type
3
Swing Clamp
4
M6 x 20mm Hex Bolt
5
M6 Spring Washer
6
M6 x OD12.5mm Flat Washer
7
M6 Plate Nut
8
M10 x 45mm Hex Bolt
9
M10 Shakeproof Washer
10
M10 x OD21mm Flat Washer
11
Fitting Instructions
Care Instruction
Clean alloy tray prior to fitting the jack holder brackets.
Tools Required
10mm Spanner
16mm Spanner
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia.
(Ph) (02) 9638 4744
(Fax) (02) 9638 4822
These instructions remain the property of Rhinorack Australia Pty Ltd and may not be used or changed for any other purpose than intended.
43101 - Rhino Pioneer Jack Holder Bracket
Qty
1
1
1
4
4
4
2
2
2
2
1
Document No: RS-451
Prepared By: Andy Wana
Authorised By: Chris Murty
Part No.
C768
C767
C769
B082
W004
W003
7
C838
B080
W021
W005
RS-451
Swing Arm Bracket
To be used at the base
plate end of high lift jack.
4
8
5
9
6
10
1
Issue No: 07
Issue Date: 11/11/2013
3
2
Page 1 of 2
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Rhino-Rack Pioneer 43101
- Page 1 RS-451 Care Instruction Clean alloy tray prior to fitting the jack holder brackets. Tools Required 10mm Spanner 16mm Spanner Rhino-Rack 3 Pike Street, Rydalmere, Document No: RS-451 NSW 2116, Australia. Prepared By: Andy Wana Issue No: 07 (Ph) (02) 9638 4744...
- Page 2 43101 - Rhino Pioneer Jack Holder Bracket Insert Plate Nuts into Alloy Tray Plate nut Insert the plate nuts into the slot at the front of the Alloy Tray and slide each nut to the desired mount location. Slot Note: Jack must be fitted to the Rear Left of tray (with base plate of jack at rear) or Front Right of tray (with base plate of jack at front).
Need help?
Do you have a question about the Pioneer 43101 and is the answer not in the manual?
Questions and answers