Advertisement
Installation of the SCU-BUD into the ScubaPro Full-Face Mask
1. Unscrew and remove the metal band that secures
the mask's left accessory port cover, to which the
lower mask strap is attached. Remove the acces-
sory port cover.
3. Install the Buddy Phone
the mask's left accessory port.
Ocean Technology Systems
®
microphone module into
2. Remove the mask strap from the accessory port
cover. Remove the male buckle end from the strap,
and set it aside. Install the mask strap into the buckle
of the Buddy Phone
4. Close the metal band around the opening of the
accessory port and tighten the screw, so that the
microphone module is securely attached.
p. 1 of 2
®
microphone module.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ocean Technology Systems SCU-BUD
Summary of Contents for Ocean Technology Systems SCU-BUD
- Page 1 Ocean Technology Systems Installation of the SCU-BUD into the ScubaPro Full-Face Mask 1. Unscrew and remove the metal band that secures 2. Remove the mask strap from the accessory port the mask’s left accessory port cover, to which the cover. Remove the male buckle end from the strap, lower mask strap is attached.
- Page 2 Cut off all excess length of tie wrap. Undersea Systems International, Inc. Ocean Technology Systems 3133 W. Harvard Street • Santa Ana • California • 92704 • USA Toll-Free (800) 550-1984 • Telephone (714) 754-7848 • Fax (714) 966-1639 • Email: ots@oceantechnologysystems.com www.oceantechnologysystems.com...
Need help?
Do you have a question about the SCU-BUD and is the answer not in the manual?
Questions and answers