Page 2
BaByliss Dry & Curl The BaByliss Dry & Curl has 2100W of power for fast drying. It has 3 heat / 2 speed settings and comes with a concentrator nozzle and diffuser, so it’s ideal for creating straight or curly styles.
Page 3
INSTRUCTIONS FOR USE General • Towel dry and detangle the hair. • There are 3 heat / 2 speed settings. Use a high heat/speed setting for rough drying. Use the low heat/speed setting as hair begins to dry and for styling and scrunch drying. •...
Cool shot button Use the cool shot button on warm hair to set the wave or curl in place for a really long lasting effect. STYLING TIPS Body & volume To help create extra body and volume in the hair, tilt your head forward so the hair is upside down when drying.
• Using a soft brush, clean any hair and other debris from the fi lter. • Replace the rear fi lter by pushing back into position. IMPORTANT! • This appliance should only be used as described within this instruction booklet. Please retain for reference. SAFETY CAUTIONS WARNING: Polythene bags over product or package may be dangerous.
Page 6
• Do not leave the appliance unattended when switched on or plugged in. • This appliance is equipped with a safety thermostat. In the event of overheating, the appliance will stop automatically. Should this happen, push the switch on the handle to the OFF position, unplug and allow to cool for 10 minutes.
UK GUARANTEE This 3 year guarantee will cover defects found due to faulty workmanship or material. Proof of purchase is required to validate the guarantee. The guarantee will be void if the damage has been caused by a fall, alteration or repair by any unauthorised persons.
ukinfo@conair.com for details of the standard repair or replacement charge. If you wish to proceed with the repair or replacement, return the product to the Conair Service Centre at the following address: Conair Service Centre PO Box 506 WIGAN WN1 9AA Enclose your name and address together with details of the fault and cheque made payable to The Conair Group Ltd.
Page 9
With the appliance, if a 13 amp plug is used a 13 amp fuse should be fi tted. If any other type of plug is used a 10 amp fuse must be fi tted either in the plug or at the distribution board.
Need help?
Do you have a question about the Dry & Curl 5548U and is the answer not in the manual?
Questions and answers