HP 41952A Operation Note page 18

(1) RF INPUT connector
The output signal from HP 4195A's OUTPUT Si , or S2 Is input
through the RF ,INPUT connector, the signal is then split and fed
to the INCIDENT and TEST PORT / REFLECTED connectors
(2) INCIDENT connector :
This connerttor is used to route a portion (INCIDENT) of the OUT-
PUT S1 or S2 signal to the HP 4195A's INPUT R1 or R2. This
signal Is Used as the refejence sIgnal for ratio measurements.
(3) REFLECTED connector : 500 N(m) connector
This connector is used to route' the REFLECTED sigmil from the
DUT to the HP 4195A's INPUT T1 or '1"2.
(4) TEST PORT connector : H P 41952A : 5 0 0 NO) connector
This connector' Is used to route the OUTPUT signal to the OUT
and to receive the REFLECTED signal from the OUT.
(5) Semi-rigid cable :1.00 N(m)-N(m) cable
This cable is used to connect HP 4195A OUTPUT S1 or S2 to the
HP 41952A/13's RF1NPUT.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
: 600 N(f) connector
600 N(m) connector
:HP 41952B : 7 5 0 N(I) connector
CAUTION1
Do not apply signals with power levels exceeding +23 dBm
to the RF INPUT and TEST PORT connectors, or damage
may result.
ICAUTION
Do not mate a 500 type-N connector to a m a type-N con-
nector or damage may result.