Warner Manufacturing EZ-Stride Step-Up Manual

Warner Manufacturing
13435 Industrial Park Blvd.
Minneapolis, MN 55441

Tools Required

1. Drill
2. ⁄ " Drill Bit
1
4
3. 2 ⁄ " Wrenches
7
16
4. #2 Phillips Screwdriver
5. ⁄ " Wrench (Rubber Feet only)
3
8
6. Hammer
7. Center Punch

WARNING:

Failure to read and follow all instructions
may result in serious injury or death.
Check for all worn or damaged parts before starting.
Replace parts with Warner brand parts only.

Hinge

Part #10314 replacement hinge part for all Warner Step-Up Benches
1. Use hammer and center punch on rivets to center the drill.
2. Drill out old rivets with
3. Replace hinge with
4. Tighten hinge bolt (check and retighten bolt in one week to ensure bolt is tight).

Spreaders

Part #10297 replacement part for 2' Bench #10225 and 2
Part #10298 replacement part for 3' Bench #10227 and 4' Bench #10228
1. Use hammer and center punch on rivets to center the drill.
2. Drill out old rivets with
3. Replace spreader with
4. Tighten bolts and then loosen
and retighten if necessary).
DO NOT over-tighten or bench will not fold properly.

Rubber Feet

Part #10296 replacement rubber feet for all Warner Step-Up Benches
1. Use ⁄ " wrench and #2 Phillips screwdriver.
3
8
2. Remove worn feet.
3. Replace with new feet and the screws and lock nuts provided.
WARNING:
Check all bolts daily to ensure safe operation.
If you need assistance or have any questions, please call Warner Customer Service at 1-800-444-0606.
Step-Up Bench Replacement Parts
⁄ " drill bit (CAUTION: Do not over-enlarge the holes).
1
4
⁄ -20 screws and nuts provided.
1
4
⁄ " drill bit (CAUTION: Do not over-enlarge the holes).
1
4
⁄ -20 screws and nuts provided.
1
4
⁄ turn to allow the bracket to pivot (check daily
1
4
Part #10314
Part #10297
Part #10298
Part #10296
⁄ ' Bench #10226
1
2