Advertisement
Maintenance
1. To clean the product surface, acidic or strong alkaline detergent
especially organic solvent (thinner, acetone, ammonia, etc.)
should never be used. Strong household cleanser is prohibited.
2. Use polishing agent to polish, you may maintain the product
surface bright and glossy as new one.
3. Scale or slight fray on the surface of the bathtub may be removed
by rubbing with a piece of soft fabric applied with a little
toothpaste
Bathtub TS-1701Q
Instructions of Installation and Use
SIZE:1700×750×550mm
※
Thank you for buying Appollo's product. Read these
Instructions of Installation and Use carefully then
keep them properly.
Because of product improvement, what described in
this instruction manual may be somewhat different
from the case of actual product you bought, and for
This we beg your pardon.
Advertisement
Table of Contents
Summary of Contents for Appollo TS-1701Q
- Page 1 SIZE:1700×750×550mm ※ Thank you for buying Appollo's product. Read these Instructions of Installation and Use carefully then keep them properly. Because of product improvement, what described in...
- Page 2 4. Adjust for levelness of the 1. Steel stand. bathtub: Install 4 M14 screw rods together Turn the bathtub back to with 12 M14 nuts and 8 φ14 flat upside-up position and place washers in the corresponding 4 it in desired location. Adjust φ15 holes in the 4 corners of the the adjusting foot bolts so that steel stand.
Need help?
Do you have a question about the TS-1701Q and is the answer not in the manual?
Questions and answers