Philips 246V5LSB/93 Service Manual page 93

Plastic mold tooling

Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush,
weld lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".

Painting to cover up cosmetic defects due to molding is strongly discouraged.

China RoHS mark requested.
Plastics flammability

All Plastics to be Flame Retardant UL 94-HB or Better.

Base / Pedestal to be Flame Retardant UL 94-HB.

All major plastic parts (bezel, back cover) need to be molded from same resin.

Plastic resin type selection should be referred to "plastic-Philips Pool monitor".
Texture/Glossing of housing

The texture area and texture no should follow Philips make-up sheet.

The exterior surfaces shall have a uniform texture.

Philips must approve the mold texturing.

Detail document for texture refer to "UN-D249", "UN-D 600".

< = 20 gloss units
Tilt and swivel base

Tilt angle

Swivel angle :

High Adjustment : nil

Portrait Display :
Kensington Lock
 Must meet Kensington_slot.spec "TYE-M0004".
 MMD request metal plate in Kensington hole.
Product dimension / Weight ( Refer to Philips approved SHT 191/SHT560 )
Transportation
Transportation standards refer to UAN-D1534/00/01/02.
Transportation packages

Net weight Packaging and wrapping shall be sufficient to protect the product against damage
or loss during shipment from the supplier to the destination specified in the purchase order.
All packaging materials are subject to test and evaluation per UAN-D1534/00/01/02.

The cushion material shall be constructed using EPS material.

The doggy hole is requested.
Transportation Test
Overall tests refer to
Vibration, drop test should be performed at ambient temperature (20°C to 23
humidity (40% to 65%).
-5  +2/- 0  (forward)
:
+20 + 0/- 3  (backward)
nil
nil
UAN-D1534/00/01/02.
Meridian 3
93
o
C) and relative