Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Knoctify Button
- Page 1 KNOCTIFY Installation and Operation Guide Thank you for purchasing Knoctify...
- Page 2 • Knoctify button • Knoctify light • Wall-mounting screws and anchors • User manual Overview Just follow these simple steps: 1. Install batteries. 2. Set up the Knoctify light and customize your preferences. 3. Mount the Knoctify button on the door.
-
Page 3: Install Batteries
Install Batteries Knoctify light Open the battery cover and install 3 AA batteries. Knoctify button Twist open the battery cover with a small coin, and install a CR2032 lithium battery. - Page 4 Reset” on page 9. Changing the light’s flashing color Press the + button to change the color of the flashing LED. It will cycle through the following colors: Red → Green → Blue → Cyan → Magenta → Orange → OFF Stop pressing the + button when you see the color you want.
- Page 5 Press the □ button to choose between 3 different vibration powers. You will feel the different vibrations. Vibrate Power 1 → Vibrate Power 2 → Vibrate Power 3 → OFF Stop pressing the □...
- Page 6 Change the tune Press the - button to change the doorbell tune. Every time you press the - button, the tune will change, and the doorbell LED will light up. Stop pressing the - button when you hear the tune you want. To turn off sound, press until there is no sound playing and the LED is turned off.
- Page 7 Waking up from power-saving mode To wake up your Knoctify light from power-saving mode, simply press any button on the side. Setting up the Knoctify button Knock detection The Knoctify Button is able to detect vibrations caused by knocking on the door’s surface. This activates the Knoctify light.
- Page 8 Knoctify button. To disable knock detection, press and hold the Knoctify button for 5 seconds until you see the blue LED. Release the button; the LED will flash four times and stop. Knock detection will be disabled.
- Page 9 Knoctify buttons. Pairing Knoctify light with Knoctify button 1. Press and hold the □ button located on the side of Knoctify light for 5 seconds. The LED will start flashing in white. The Knoctify light is now ready to accept...
-
Page 10: Maintenance
20 seconds if it does not receive any pairing request. Reset all pairings on Knoctify light 1. Press and hold the □ button on your Knoctify light for 5 seconds. The LED will start flashing in white. 2. Press the + button. The Knoctify light will stop flashing to indicate that all pairings have been removed. -
Page 11: Specifications
Knoctify light 1. Check that the batteries are does not work. installed in the right direction. 2. The Knoctify light might be out of range. Move it to a different location and try again. 3. Reset and set up pairing again. - Page 12 Range is 1. Metal structures can interfere reduced. with the wireless signal. Avoid installing the Knoctify light and button near any large metal structures. 2. Weak batteries will reduce the range. In cold conditions (below 5⁰C), the batteries may need to...
-
Page 13: Warranty
Knoctify’s sole responsibility shall be to repair or replace the product within the terms stated above. KNOCTIFY SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL... - Page 14 OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. If you have any questions concerning this warranty, please email Knoctify Customer Care at support@knoctify.com.