OMG OlyFlow Hercules Retrodrain Installation Instructions

HERCULES RETRODRAIN
®
INSTALLATION INSTRUCTIONS
M E E T S A N S I / S P R I R D - 1 S TA N D A R D
For Use With: All types of roof covers.
Job Preparation: Remove existing strainer dome and
clamping ring. Remove other existing drain components
as required to enable Hercules Drain flange to lie flush
on roof membrane. Remove any debris or constricting
materials in the existing drain pipe that interferes with
proper installation.
For technical assistance
contact OMG at 800 . 633 . 3800.
153 BOWLES ROAD
AGAWAM, MA 01001
800 . 633 . 3800
WWW.OLYFAST.COM
S T E P
Examine the existing water leader to make sure there are
no elbows that prevent the drain stem from being fully
1
inserted into the pipe. (If an elbow is present, follow
directions on reverse for shortening drain stem.) Insert
U-Flow Seal into end of drain stem and tighten screws
®
enough to hold the seal in place during installation. Insert
assembled drain into existing leader pipe until flange lies
flush on roof membrane.
S T E P
Alternately tighten seal compression ring screws with
U-Flow Screw driver until hand tight. Hercules Drain body
2
is correctly installed when pressure placed on drain body
results in no vertical movement. Do not overtighten
the screws.
S T E P
Secure the drain flange to the roof deck/nailer using
a minimum of three pan-head fasteners, evenly spaced
3
around the flange. The flash ing membrane must cover and
extend past the fastener head. Flash ing membrane must
be installed per roof membrane manufacturer's detail.
S T E P
Place clamping ring over metal studs. Install stainless
steel nut and lock washers tightening clamping ring
4
against membrane flashing until secure.
S T E P
Install strainer dome by aligning screw holes with the
holes in the clamping ring. Secure with screws provided.
5
OlyFlow ™ , U-Flow ® , Hercules ® and RetroDrain ® are trademarks of OMG, Inc.
Copyright © 2011 OMG, Inc.
Hercules
Roof Membrane
Drain Body
Deck
U-Flow Seal
Existing Drain
1
Existing Pipe
U-Flow
Screwdriver
2
Flashing Membrane
(Refer to project specifications)
3
Clamping
Ring
Metal Stud
4
Strainer
Dome
5