ILP RB3 Series Installation Instructions

PLEASE READ INSTRUCTIONS BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCE.
Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician.
1. To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all warnings
and instructions included with and on the fixture box and all fixture labels.
2. Before installing, servicing, or performing routine maintenance on this luminaire, follow these general precautions.
3. Installation, service and maintenance of luminaries should be performed by a qualified licensed electrician.
4. For the installation: If you are unsure about the installation or maintenance of the luminaire, consult a qualified licensed electrician and check your local
electrical code.
5. To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
6. Please keep the RB3 away from any corrosive substance. When you clean it, please use damp or dry cloth.
1. Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
2. Turn off the power when you perform any maintenance.
3. Verify that supply voltage is correct by comparing it with the luminaire label information.
4. All wiring connections should be capped with UL approved wire connectors.
5. Suitable for Wet Locations
Installation Steps
REFLECTOR / DIFFUSER INSTALLATION (OPTIONAL)
·
Insert provided screws to the designated locations on the fixture housing. Install screws half way, leaving enough space (1/8" – 3mm) between the housing and
the end of the screws to be able to insert through the keyholes of the reflector/diffuser (Figure 1).
·
Align the reflector/diffuser with the housing and insert screws through the reflector/diffuser keyholes. Rotate clockwise to lock the reflector/diffuser (Figure 2).
·
Lock the screws to secure the reflector/diffuser (Figure 3).
·
Finished result as shown in (Figure 4).
·
Follow RB3 installation steps to complete the installation.
Screw
Figure 1
CAUTION
!
WARNING
!
WARNING
!
General Wiring Diagram
Black (Line)
White (Neutral)
100-277V
Green (Ground)
Reflector
Figure 2
LED ROUND HIGH BAY
INSTALLATION INSTRUCTIONS
LED DRIVER
Figure 3 Figure 4