SunReports Apollo2 Quick Start Manual

SunReports
10

Optional: Configure Apollo for Static IP.


Connect Apollo to a DHCP router. Find the IP
address assigned to the Apollo (typically via the
router setup interface) and connect to the IP
address (e.g. http://192.168.1.2/setup.html) with a
browser, Configure the IP Address, Mask, Gateway
and DNS

Power cycle Apollo to enable changes
IMPORTANT:
!
be coordinated with the customer's IT staff
11
Record the customer information and
sensor label names on the included
Configuration Sheet
IMPORTANT:
!
needed to properly set up the unit on
www.sunreports.com
we help you monitor:
solar pool
solar electric solar hot water
heating
Printed using 30% post consumer recycled content by:
Copyright © 2010, SunReports. All Rights Reserved
20100819
RealizeYourPower
T M
www.sunreports.com
This is an advanced configuration and must
This information will be
for more information go to:
www.sunreports.com
bay area
www.bayareagreenprinting.com
SunReports

Quick Start Guide

1
Add one serial number sticker from the
box to the Configuration Sheet
One sticker may be left with the end
user for their records
! IMPORTANT:
entered into the on-line system
MUST match the number on the
unit. This is what allows for the
mapping, identification and
environmental information
Page 4
RealizeYourPower
T M
www.sunreports.com
Apollo2
Solar Pool Systems
For detailed instructions, see the
Apollo Installation Manual from www.sunreports.com

General Configuration

T1
T2
The serial number
Page 1