Network Requirements - Markforged Onyx Series Quick Start Manual

INDUSTRIAL PRINTER QUICK START GUIDE

NETWORK REQUIREMENTS

Markforged devices communicate on the 2.4GHz Wi-Fi band. For assistance with setting up your network,
contact your internal IT team.
WIRED CONNECTIONS
Ethernet connection must utilize cables less than 30 meters in length.
FIREWALL SETTINGS
Markforged products support DHCP only; there is no support for static IP addresses. If a static IP is needed, the
network's DHCP server should be configured with a "reservation" or static host entry assigning the desired IP
address to the printer's MAC address; to find the printer's MAC address, see Connecting Your Printer, above.
For proper operation, printers must be able to make outbound connections to services at the following
hostnames on the given ports (no inbound connections are needed):
HOSTNAME
s3.amazonaws.com
mfeiger-production.
s3.amazonaws.com
cdn.eiger.io
www.eiger.io
*.pool.ntp.org
ipv4.connman.net
data.logentries.com 443
data.logentries.com 10000 TCP
PORT PROTOCOL REQUIRED REASON
443 TCP
443 TCP
443 TCP
123 UDP
80 TCP
TCP
yes Downloading .MFP part files
produced by Eiger and consumed
by printers
yes Device operation
yes Connecting to Eiger (required for
viewing printer status, queuing print
jobs, keeping printer software up to
date, etc.)
yes Time synchronization via NTP is
required for printers to connect
securely to Eiger; see Printer Time
Synchronization, below
no Network connection status check
(primarily used for troubleshooting)
no Remote logging of printer events
and errors
no Legacy setting for remote logging,
only required if software version is
older than 09/14/2018
15