Advertisement
10. Turn power back ON.
11. Adjust the knob to the desired relative humidity level.
12. Allow system to level. This may take a day or two. Turning
the knob to "on" position will not reach level faster. Adjust
as needed to reach comfort level.
INSTRUCTIONS FOR WALL MOUNTING
Fig. 2 - - Wall- -Mount Diagram
1. Turn OFF power to the humidifier.
2. Select the location for the humidistat. Choose a centrally lo-
cated interior wall away from doors and windows.
3. Using the mounting template (Fig. 4) on Pg. 3, drill the four
mounting holes using a 5/64" (2mm) drill bit. Next drill the
hole for the wire leads using a 3/8" (10mm) drill bit.
4. Run the thermostat cable through the wire lead hole to the
humidifier. Ensure there is enough cable for the 24 volt
transformer also. Refer to wiring diagram. Leave about 6"
(15cm) of thermostat cable sticking out of the wall. This
will be connected to the humidistat.
5. Remove the control knob and cover. Fasten the unit to the
wall using the screws provided. Use appropriate anchors
(sold separately) when fastening to drywall.
6. Join the wire leads to the thermostat cable using the wire
connectors provided.
7. Replace the cover on the unit. Remove the paper backing
from the humidistat label and apply to the face of the cover.
Attach the knob to the control shaft. Turn knob to the "off"
position.
8. Connect thermostat cable to the humidifier and transformer.
(Refer to humidifier installation instructions for system
wiring options.)
9. Turn power back on.
10. Adjust the knob to the desired relative humidity level.
11. Allow system to level. This may take a day or two. Turning
the knob to "on" position will not reach level faster. Adjust
as needed to reach comfort level.
A13351
2
Advertisement
