Download Print this page

Silent Alert SA3000 System Quick Setup Manual

Universal monitor as a baby alarm

Hide thumbs Also See for SA3000 System:

01/06/2011

Quick Setup Guide

Silent Alert SA3000 System

UM3A-2212-EU

Universal Monitor as a Baby Alarm

Step 1

Move control switches 5 & 13 to the On position as illustrated.

Switch audio delay keys as required to the On position. Keys 8 shown in the On position.

Key 7 = 0.5 second, Key 8 = 1.5 second, Keys 7 & 8 = 2 seconds

Turn the sensitivity control to the position shown. It may be necessary to fine-tune this setting.

Off position

Attach a 9-volt Alkaline Battery and or Power Supply. Plug the Power Supply into a nearby mains

socket and switch the socket on. It is likely that the unit will trigger during handling and send a

signal to the Pager or SignWave, this is normal.

Universal Monitor as a

Baby Alarm

Turned 90 degrees clockwise

Table of Contents

Do you have a question about the SA3000 System and is the answer not in the manual?

Page 1 01/06/2011 Quick Setup Guide Universal Monitor as a Silent Alert SA3000 System Baby Alarm UM3A-2212-EU Universal Monitor as a Baby Alarm Step 1 Move control switches 5 & 13 to the On position as illustrated. Step 2 Switch audio delay keys as required to the On position. Keys 8 shown in the On position.
Page 2 6 feet (2 metres) from the Baby’s cot. Step 6 Make an noise or Blow the Silent Alert setup whistle close to the Baby’s Cot and observe the status light. When the monitor detects a sound the light will shine amber. When the delay period of 0.5, 1.5 or 2 seconds is exceeded the light will change to green and the monitor will send a baby signal...

Um3a-2212-eu