MGA Entertainment Project MC2 Circuit Beats Manual

CIRCUIT BEATS™
539247
TM
CONTENTS
A. 1 Speaker Headband
B. 1 Circuit Board Controller
A.
B.
C. x7
Illustrations are for reference only. Styles may vary from actual contents.
ITEMS YOU WILL NEED (NOT INCLUDED)
Have an adult help you gather all the household items needed and supervise during the experiment.
You can use any object that contains moisture such as:
Go to YouTube.com for more ideas!
Banana
Flower In Water A Friend's Arm Orange Slice
BEFORE YOU BEGIN
The batteries included in Circuit Beats™ are for in-store demonstration. Before playing an ADULT
must install fresh alkaline batteries. Here's how:
1. Remove the pull tab undeneath the circuit board controller and discard.
2. Using a Phillips screwdriver (not included) loosen the screw and remove the battery
compartment cover from the bottom of the controller.
3. Install three (3)1.5V (LR03)AAA alkaline batteries (not included) making sure the (+) and (-) ends
face the proper direction as indicated inside the battery compartment.
4. Replace the compartment cover and tighten the screw.
pull tab
6+ YEARS
1
ADULT SUPERVISION REQUIRED
C. 7 Wires with Clips
D. 1 Sticker Sheet
D.
3
Plug in one wire into the grounding wire port on the bottom left side of the controller.
Strawberry
Ice Cream
3 x 1.5 V
AAA (LR03) Batteries
1.5V AAA/LR03
1.5V AAA/LR03
1.5V AAA/LR03
SETTING UP YOUR CIRCUIT BEATS™
NOTE: Before beginning, cover the play area to avoid possible damage from food spillage.
Unplug the cable from the right side of the controller.
5
Connect the clip on the end of the grounding wire to your index finger. Then, connect the remaining clips to
objects that conduct electricity. These are usually things that hold moisture. What else can you try?
2
Put on the speaker headband and plug it into the port on the top left side of the controller.
4
Plug the remaining six wires into the ports on the front of the controller.