Disaster Area Designs DPC.micro User Manual page 3

c
OntrOllIng
This part is pretty simple! Tap the footswitches labeled A, B, and C to change the status of the
A, B, and C loops. That's pretty much it - three loops, no waiting.
Hold the C (SAVE) footswitch to save
the current loop settings to the last
active preset.
If you're using the DPC.micro with a MIDI controller, we recommend you keep it in Loop
Mode. This will allow you to see the current loop states, as well as override the loop controls
if desired.
Y P
Our edals
LOOP MODE
Tap the footswitches to engage or
bypass each loop.
The loop state is indicated by the LED
next to each footswitch.
HOLD
Hold the A (MODE) footswitch to
switch between LOOP and PRESET
modes.
HOLD
PRESET MODE
Tap the footswitches to select a
preset. ALL LEDs will flash red, then
the current preset will light in WHITE.
Tap the current preset to load preset
zero (bypass or favorite.)