ELEQ LS-74 Installation Manual

Technical Specification
Technical Specification
Technical Specification
Safety and environmental conditions
Safety and environmental conditions
Safety and environmental conditions
CE marking LV directive 2006/95/EC
CE marking LV directive 2006/95/EC
CE marking LV directive 2006/95/EC
RoHS directive 2011/65/EU
RoHS directive 2011/65/EU
RoHS directive 2011/65/EU
WEEE directive 2012/19/EU
WEEE directive 2012/19/EU
WEEE directive 2012/19/EU
EN-IEC 61439-2:2011
EN-IEC 61439-2:2011
Standard EN-IEC 61439-2:2011
Standard
Standard EN-IEC 60269-3:2013
EN-IEC 60269-3:2013
EN-IEC 60269-3:2013
This product is designed to be safe under the following
This product is designed to be safe under the following
This product is designed to be safe under the following
conditions:
conditions:
conditions:
Specification
Specification
Specification
Environmental conditions
Environmental conditions Environmental conditions
Operating temperature: -5°C - +55°C
Operating temperature: -5°C - +55°C
Operating temperature: -5°C - +55°C
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Protection degree: IP23
Protection degree: IP23
Protection degree: IP23
Installation class: 1 (protective earth)
Installation class: 1 (protective earth)
Installation class: 1 (protective earth)
Pollution degree: 2
Pollution degree: 2
Pollution degree: 2
Application conditions
Application conditions
Application conditions
Umax:
Umax: 230/400V
Umax: 230/400V
230/400V
Frequency: Frequency:
Frequency: 50Hz 50Hz
50Hz
Imax: Imax:
Imax: 50A (mantle terminals) 50A (mantle terminals)
50A (mantle terminals)
Imax to armature:
Imax to armature:
Imax to armature: 6A 6A
6A
Fuse: Fuse:
Fuse: 5L5001: DII (E27), max 6A 5L5001: DII (E27), max 6A
5L5001: DII (E27), max 6A
5L5301: D01 (E14), max 6A 5L5301: D01 (E14), max 6A
5L5301: D01 (E14), max 6A
Strain relief:
Strain relief: Strain relief: Yes, maximum two ground cables
Yes, maximum two ground cables Yes, maximum two ground cables
18mm and 1 light pole cord 18mm and 1 light pole cord
18mm and 1 light pole cord
Maximum wire cross section
Maximum wire cross section Maximum wire cross section
and torque:
and torque: and torque: Terminal 1, 2, 3, 4, 5: 2x 10mm
Terminal 1, 2, 3, 4, 5: 2x 10mm Terminal 1, 2, 3, 4, 5: 2x 10mm
or 3x 6mm
or 3x 6mm
or 3x 6mm
Terminal 5, 6, 7, 8: 4mm
Terminal 5, 6, 7, 8: 4mm
Terminal 5, 6, 7, 8: 4mm
Diameter ø
Diameter ø Diameter ø 74mm
74mm 74mm
Height 265mm
Height 265mm
Height 265mm
Storage
Storage
Storage
Temperature: -20°C - +70°C
Temperature: -20°C - +70°C
Temperature: -20°C - +70°C
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Approval KEMA-keur
Approval KEMA-keur
Approval KEMA-keur
Specification per type
Specification per type
Specification per type
5L5001 5L5001 5L5001-6A 5L5001-6A
5L5001 5L5001-6A
Fuse included 6A
Fuse included 6A
Fuse included 6A
Neutral
Neutral
Neutral
Disconnector
Disconnector
Disconnector
Weight 450gr 520gr
Weight 450gr 520gr
Weight 450gr 520gr
Please be aware, product liability, fulfilment to requirements and
Please be aware, product liability, fulfilment to requirements and
Please be aware, product liability, fulfilment to requirements and
warranty are all expired when modifications on the product are made. warranty are all expired when modifications on the product are made.
warranty are all expired when modifications on the product are made.
ELEQ reserves the right to carry out modifications on its products, in
ELEQ reserves the right to carry out modifications on its products, in
ELEQ reserves the right to carry out modifications on its products, in
order to improve them, without prior notice.
order to improve them, without prior notice.
order to improve them, without prior notice.
Safety instruction
Safety instruction
Safety instruction
All activities for installation, commissioning and maintenance of
All activities for installation, commissioning and maintenance of
All activities for installation, commissioning and maintenance of
this connection box must be performed by qualified personnel
this connection box must be performed by qualified personnel
this connection box must be performed by qualified personnel
that has the knowledge of applicable safety precautions. This
that has the knowledge of applicable safety precautions. This
that has the knowledge of applicable safety precautions. This
guide assumes that the reader of this document has sufficient
guide assumes that the reader of this document has sufficient
guide assumes that the reader of this document has sufficient
electro-technical knowledge to understand the content of this
electro-technical knowledge to understand the content of this
electro-technical knowledge to understand the content of this
document.
document.
document.
General
General General
The LS-74 is a connection box for public lighting and intended
The LS-74 is a connection box for public lighting and intended
The LS-74 is a connection box for public lighting and intended
to be used in lighting poles. The connection box should be
to be used in lighting poles. The connection box should be
to be used in lighting poles. The connection box should be
mounted in a weather protected and dry location. In the
mounted in a weather protected and dry location. In the
mounted in a weather protected and dry location. In the
connection box the incoming (ground) cable can be connected.
connection box the incoming (ground) cable can be connected.
connection box the incoming (ground) cable can be connected.
If desired, looped circuits wiring to the next lighting pole is
If desired, looped circuits wiring to the next lighting pole is
If desired, looped circuits wiring to the next lighting pole is
possible. The cable of the armature should be connected on
possible. The cable of the armature should be connected on possible. The cable of the armature should be connected on
the outgoing terminals.
the outgoing terminals.
the outgoing terminals.
Fuses protect the installation against overload and short-
Fuses protect the installation against overload and short-
Fuses protect the installation against overload and short-
circuiting.
circuiting. circuiting.
Explanation of symbols Explanation of symbols
Explanation of symbols
2
2 2
2 , 2-4Nm
2 , 2-4Nm
2 , 2-4Nm
2 , 1-2Nm
2 , 1-2Nm
2 , 1-2Nm
5L5103 5L5103
5L5103
6A
6A
6A
Yes
Yes
Yes
540gr
540gr
540gr
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
+31 (0) 521 533 333
This This product product is is designed designed according according
This product is designed according
EN-IEC 61439-2:2011 standards and meets the
EN-IEC 61439-2:2011 standards and meets the EN-IEC 61439-2:2011 standards and meets the
requirements of the Low Voltage Directive 2006/95/EC. requirements of the Low Voltage Directive 2006/95/EC.
requirements of the Low Voltage Directive 2006/95/EC.
Read the installation guide before mounting the
Read the installation guide before mounting the Read the installation guide before mounting the
product. Unprofessional work activities on electrical
product. Unprofessional work activities on electrical
product. Unprofessional work activities on electrical
installations may result in a threat of danger to the life
installations may result in a threat of danger to the life installations may result in a threat of danger to the life
and health of human beings and livestock!
and health of human beings and livestock! and health of human beings and livestock!
RoHS Directive 2011/65/EU
RoHS Directive 2011/65/EU
RoHS Directive 2011/65/EU
ELEQ states that it uses qualified components in its
ELEQ states that it uses qualified components in its
ELEQ states that it uses qualified components in its
products only from manufacturers which meet the
products only from manufacturers which meet the
products only from manufacturers which meet the
requirements of the European Directive for the
requirements of the European Directive for the
requirements of the European Directive for the
"Restriction of use of certain Hazardous Substances
"Restriction of use of certain Hazardous Substances
"Restriction of use of certain Hazardous Substances
WEEE Directive 2012/19/EU
WEEE Directive 2012/19/EU
WEEE Directive 2012/19/EU
This equipment should not be disposed as unsorted
This equipment should not be disposed as unsorted
This equipment should not be disposed as unsorted
municipal waste. Contact a qualified recycler for
municipal waste. Contact a qualified recycler for
municipal waste. Contact a qualified recycler for
disposal.
disposal.
disposal.
info@eleq.com www.eleq.com 83715
83715
83715
83715 / EN1603
LS-74 Connection Box for
LS-74 Connection Box for
LS-74 Connection Box for
Public Lighting
Public Lighting
Public Lighting
Installation Guide
Installation Guide
Installation Guide
to to the the
to the
LS-74
LS-74
LS-74
Read this installation guide before installing the product
Read this installation guide before installing the product
Read this installation guide before installing the product
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
+31 (0) 521 533 333 info@eleq.com
/ EN1512
/ EN1512
/ EN1512
5L5103
5L5103
5L5103
5L5001
5L5001
5L5001
5L5001-6A
5L5001-6A
5L5001-6A
5L5103
5L5103
5L5103
www.eleq.com