Download Print this page

Butts of Bawtry BAT0001 Original Instructions Manual

3/8" keyless reversible air drill

Advertisement

Quick Links

3/8" KEYLESS REVERSIBLE AIR DRILL
BAT0001
ORIGINAL INSTRUCTIONS
SAVE THESE INSTRUCTIONS AND PRECAUTIONS.
READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.

Advertisement

loading

Summary of Contents for Butts of Bawtry BAT0001

  • Page 1 3/8" KEYLESS REVERSIBLE AIR DRILL BAT0001 ORIGINAL INSTRUCTIONS SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
  • Page 2: Safety Instructions

    1. SAFETY INSTRUCTIONS •WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment. •WARNING! Disconnect from air supply before changing drill bits, or servicing ,or performing any maintenance. •Maintain the drill in good condition •Replace or repair damaged parts.
  • Page 3 failure and/or personal injury. •WARNING! DO NOT drill any materials containing asbestos. •DO NOT carry the drill by the hose, or yank the hose from the air supply. •DO NOT force, or apply heavy pressure to the drill; let the tool do the work. •DO NOT place air line attachments close to your face and do not point at other people or animals.
  • Page 4 3.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). The minimum hose diameter should be 1/4” I.D. and fittings must have the same inside dimensions. 3.1.7. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all connections are secure.
  • Page 5: Using The Drill

    working correctly before starting work. 4.2.1. DO NOT allow drill to run freely for an extended period of time as this will shorten the life of bearings. WARNING! Ensure you wear approved safety goggles and any other safety items required for the job. Also ensure that all other safety requirements are followed 4.3.
  • Page 6 WARNING! Disconnect drill from air supply before changing drill bit, servicing or performing maintenance. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty. 5.1. If the air supply does not have an oiler, lubricate the drill daily with a few drops of good grade air tool oil, dripped into the air inlet before use or dispensed automatically through an air system oiler.
  • Page 7: Assembly Diagram And Parts List

    6. ASSEMBLY DIAGRAM AND PARTS LIST...