Ortech RTD User Manual page 9

Re-Install the Control
into the Cutout
Organize Wire Lead
Feed the wiring harness back into the grill's cutout.
Insert the control into the cutout. Install the control's circuit
board into the cutout at an angle to ensure the circuit board
fits through the cutout without damage.
WARNING: Do not force the control into the cutout.
Bumping electronic components into the edge of the
cutout during installation may damage the control.
Retrieve the two faceplate mounting screws that were used
to hold the control in place.
Using a medium Phillips screwdriver, install the top faceplate
screw and lightly tighten. Install the bottom faceplate screw
and tighten. Tighten the top faceplate screw.
If necessary, use the tie wrap to tie back the temperature
detector wire lead and the control's wiring harness to ensure
they do not interfere with the draft fan and other grill
components.
6