Advertisement
www.bastl-instruments.com
technical details
� 4HP width
� 35mm deep (skiff friendly)
� power consumption: +12: <15mA, -12: <35mA, +5: <35 mA
� PTC fuse and diode protected 16 pin power connector
� requires +5V from the power supply bus board
� signal input
� inverted output
� 2x buffered, low-offset outputs (ca. 0.015%)
� unity gain mixer with 2 MIX inputs 1 MIX OUT
� bipolar LED to visualise each signal
independently (visible from 2Volts)
� handmade in Brno, Czech republic
Before connecting the ribbon cable to this module
disconnect your system from power !
!
Double check the polarity of the ribbon cable and that
it is not shifted in any direction. the red cable should
match the -12V rail both on the module and on the
bus board !
please make sure of the following
� you have a standard pinout eurorack bus board
� you have +5V, +12V and -12V rails on that bus board
� the power rails are not overloaded by current
Although we put protection circuits in the device,
we do not take any responsibility for damages
caused by wrong power supply connection.
After you connected everything, double-checked
it and closed your system, so no power lines can
be touched by hand, turn on your system and test
the module.
Advertisement
