Panasonic ER-GD60 Operating Instructions Manual page 12

Trimming height comb attachment
• Make sure that the trimmer is turned off.
• Actual beard length will be a little longer than the height you set.
• The desired results may not be achieved if beard is too long.
In this case, trim the beard to a length of about 20 mm before
using the trimmer.
• For areas with thick or dense beard growth, trim a bit at a time.
Beard sometimes gets caught or builds up in the attachment.
When this happens, clean the attachment. (See page 13.)
1
Turn the dial and adjust the
trimming height indication
mark (a) to the desired height.
• Trimming height (estimate): 0.5 mm to 10 mm
Indicator 0.5 1 1.5 2 2.5 3 3.5 4 4.5 5
Trimming height (mm)
0.5 1 1.5 2 2.5 3 3.5 4 4.5 5
(estimate)
Indicator 5.5 6 6.5 7 7.5 8 8.5 9 9.5 10
Trimming height (mm)
5.5 6 6.5 7 7.5 8 8.5 9 9.5 10
(estimate)
12
2
Apply the flat part of the comb against your skin
and cut your beard by combing it left and right.
Removing and mounting the attachments
• Take care not to injure hands, etc., with the blade when removing
or mounting the attachment.
• Make sure that the trimmer is turned off.

Mounting the attachment
Mount the attachment to the
main body until it clicks.
• If the attachment is not
attached correctly, it may shift
and end up cutting too much
during use.
Removing the attachment
Hold the main body securely and
remove the attachment from the
main body.
• Hold the rib (b) part securely
and remove the detail trimming
attachment.
Flat part of the comb
click
