Chamberlain LiftMaster 580LM Quick Start Manual

Carton Inventory
WARNING
CAUTION
Transformer (1)
Insulated Staples (30)
Low Voltage Wire 35'
Optional Low Voltage Wire 50'
(Not Shown) 41A6669
Installation (Figure 1)
NOTE: For use only with Residential Jackshaft Openers.
Disconnect all power to the opener if already installed.
1
Disconnect the Standby Power Unit
installed.
Determine mounting location for the interface within
2
3' (.9 m) of opener. Mount and secure with screws and
anchors.
Plug interface into opener.
3
Position transformer within 1' (.3 m) of outlet, secure with
4
screws and anchors.
NOTE: If transformer is being secured to ceiling, the
transformer must be secured to a ceiling joist.
Separate low voltage wires. One end of the wire is prepared
5
for convenience. Cut wire to appropriate length and strip
7/16" (11 mm) of insulation from the end of the wire.
Use one of the stripped wires to connect COM screw
6
terminals on the interface and transformer. Use the other
stripped wire to connect 24V screw terminals. (Polarity is
not important.)
Before permanently mounting, reduce slack in cord. Secure
7
with insulated staples.
Use cable tie to bind power cord from opener. Be sure to
8
keep power cord away from rail and out of the reach of
children.
Plug transformer into the outlet. To reduce the risk of electric
9
shock, your garage door opener has a grounding type plug
with a third grounding pin. This plug will only fit into a
grounding type outlet. If the plug doesn't fit into the outlet
you have, contact a qualified electrician to install the proper
outlet.
NOTE: Opener may operate at a slower speed while using
this device.
Connect to Standby Power Unit
(Not Provided) (Figure 2)
Connect the SPU connector from the SPU to the interface.
NOTE: If connecting to a standby power unit, the interface and
SPU must be within 3' (.9 m) of each other.
Interface (1)
Screws (8)
Cable Tie (1)
Anchor (8)
®
from the opener if it is
®
(SPU)
Models 580LM & 580LMC
Residential Jackshaft Opener Alternate
WARNING WARNING
To prevent possible SERIOUS INJURY or DEATH from electrocution
or fire:
WARNING
• Disconnect power to opener BEFORE proceeding.
• NEVER use an extension cord, 2-wire adapter, or change plug in
any way to make it fit outlet. Be sure the opener is grounded.
NOTE: If the Smart Control Panel is showing the message
"Battery Back-up enabled" or the LCD Backlight is not on under
power from the Alternate Power System contact service at
1-800-528-9131.
Figure 1
9
Figure 2
Power System Accessory
8
2
COM 24V
7
4-6
3
4-6